4. Motion Control Instruction 4.7.8. The technological parameters of flying shear function The figure of flying shear function: 4-172 DVP-MC operating manual Parameter in Description Name in the instruction figure R1 The radius of master axis, i.e. the radius of the feed roller MasterRaduis R2 The radius of slave axis, i.e. the radius of the corresponding roller of slave axis. By adopting the lead screw, R2= Lead of the lead screw / 2π=S/2π SlaveRadius A The wait position of slave axis. After the flying shear function is started up, slave axis will run to the position automatically. SlaveWaitPosition B The start position of master axis.
When master axis reaches this position, slave axis will chase the master axis starting from the wait position to realize the synchronous speed. MasterStartPosition C The corresponding master position when synchronous area starts. MasterSyncPosition D The corresponding slave position when synchronous area starts. SlaveSyncPosition E The corresponding slave position when synchronous area ends. SlaveEndPosition L The cutting length of material CutLength