STARTING AND DRIVING speed by 5 km/h each time. Press and hold to increase/ decrease the vehicle speed by 1 km/h continuously. ■ Adjust the speed via the acceleration/deceleration key on the left keypad of the steering wheel until the desired speed value is reached (the speed at this time is the set cruise speed). ACC can be temporarily disabled by pressing the set key or by depressing the brake pedal. VESPER Automatic standby mode A temporary increase of speed by depressing the accelerator pedal, such as accelerating during overtaking, does not affect the setting. The vehicle speed returns to the last stored value when the accelerator pedal is released.
ACC switches automatically to standby mode if: ■ The driver seatbelt is unbuckled. ■ Any one of the four doors and the two covers is open. ■ The engine is shut down. ■ In manual mode. ■ The gear lever is not in D position. ■ TCS enabled. ■ HDC enabled. ■ ABS enabled. ■ ESP turned off. ■ EPB switch is pulled up. ■ The vehicle speed is too high. ■ The close target to follow is lost. ■ The auto emergency braking system is enabled. ■ The transmission oil temperature is too high. Disable/re-enable Adaptive Cruise Control (ACC) Warning! The ACC can be temporarily put into standby mode and then resumed. If this happens, a corresponding message appears in the instrument cluster as a reminder.
At this time, you must take over the speed control, depress the brake pedal if necessary, and keep a safe distance from the vehicle ahead. Otherwise accidents may be caused, resulting in personal injury or death. Disable ACC 192