VLT ® 2000 Series Setup 1 Setup 2 109 START VOLTAGE V 110 START COMP. V/A 111 V/F RATIO V/HZ 112 SLIP COMP HZ 114 FEEDBACK TYPE VOLTAGE 10 V X CURRENT 20mA PULSES 119 FEED FWD. FACTR % 120 CONTRL RANGE % 121 PROPRT/L GAIN 122 INTEGRAL TIME SECONDS 125 FEEDBACK SCALE % 200 FREQ RANGE X X 120 HZ 500 HZ 201 MIN. FREQUENCY HZ 202 MAX. FREQUENCY HZ 203 JOG FREQUENCY HZ 204 DIG. REF.
TYPE X SUM Setup 1 Setup 2 403 INPUT 19 X REVERSING LATCH REV NO OPERATION SPEED DOWN SPEED SELECT RESET 404 INPUT 27 MTR.COAST Q-STOP not DC-BRAKE not X RST&COASTnot STOP not RESET & START SPEED UP SPEED SELECT 405 INOUT 29 X JOG START DIG.REF+START PULSES 100 HZ PULSES 1 KHZ PULSES 10 KHZ SELECT SETUP RESET REVERSING SPEED DOWN 408 LOG OUTPUT 46 UNIT READY X X UNT RDY RCTL ENABLEDnoWR RUNNING RUNNINGnoWR RNINRGE noWR RUN@REFnoWR NO WARNING ALARM ALARMorWARN CURRENT LIM OUT FRQ RGE OUT CURR RGE PULSOUT 1500 PULSOUT 3000 PULS-PAR 005 SEND/REC NEG SEND/REC POS Factory settings and service Section 1 Section 2 Section 3 RELATIVE 205 DIG. REF. 1 % 206 DIG. REF. 2 % 207 DIG. REF. 3 % 208 DIG.
REF. 4 % 209 CURRENT LIMIT A 210 LOW FREW WARN. HZ 211 HI FREQ WARN. HZ 213 HI CURR WARN. A 215 RAMP UP TIME SECONDS 216 RAMP DOWN TIME SECONDS 218 ALT: DOWN RAMP SECONDS 224 CARRIER FREQ. KHZ 230 SPEED UP/DOWN X DISABLED ENABLED ENABLE&STORE 300 BRAKE OPTION X NOT APPLIED APPLIED 306 DC-BRAKE TIME SECONDS 307 DC-BRK ON FREQ HZ 308 DC-BRK VOLTAGE V 309 RESET MODE X MANUAL AUTORESET 1 AUTORESET 5 310 TRIP DLY@C.LIM SECONDS 315 MOTOR THERMALX X PROTECT-OFF ONLY WARNING TRIP 402 INPUT 18 X START LATCH START NO OPERATION SPEED UP SPEED SELECT REVERSING RESET&START COAST/START X = factory settings MG.20.B6.02 – VLT is a registered Danfoss trademark 103