Name and Function of Each Part Front panel Buttons and switches equipped vary depending on the model. (Pattern A or B) Check your printer and understand how to use it. Pattern A Pattern B 23 No. Name Description 1 Foreign material detection sensor switch Use this switch to change the operation the foreign material detection sensor. Off: Disable On: Enable Note that Epson shall bear no responsibility for any outcome that occurs as a result of how the foreign material detection sensor is set. Do not turn this function off, except when removing an impediment. 2 External winder switch Use this switch to change the signal from an external winder. Off: Disable On:
Enable 3 Back feed button Press and hold this button to feed the belt in the reverse direction (from front to rear). 4 Pause button Printing is paused and the print head comes to a stop either on the flushing plate or at the cleaning station area. Press the [Start] icon for Leonardo to resume printing. 5 Foreign material detection sensor controller Use this to set and display the detection threshold value of the foreign material detection sensor. For the threshold value, refer to "Set the Foreign Material Detection Sensor" on Page 73. 6 Feed button Press and hold this button to feed the belt in the forward direction (from rear to front).
7 Foreign material detection sensor off button The foreign material detection sensor is turned off (disabled) while this button is pressed. Note that Epson shall bear no responsibility for any outcome that occurs as a result of how the foreign material detection sensor is set. Do not push this button, except when removing an impedi- ment.