The supported diameter of outer cable sheath ranges from 17 to 22 mm. For chargers rated at 7kW / 22kW, the minimum size of each wire is 6mmІ. For chargers rated at 11kW, the minimum size of each wire is 2.5mmІ. 7. Loosen the five terminal screws with a Phillips screwdriver and fully insert each wire connector into its correct terminal block. Use a torque screwdriver to tighten the terminal screws with a torque of 19.6 N.cm. (See Fig. 5-16) Fig. 5-16 Note: 1. For the model of PulseQ AC Pro_7K_S_EU, only connect the corresponding wire conductors to the L1, N, PE connectors. 2. Carefully install the wires to avoid damage to the Control Pilot (CP) wire. 25 CARD