Administrator Information > Advanced Security Settings > Controlling Using Protocols Controlling protocols Configure the protocol settings supported by the scanner. 1. Access Web Config and then select the Network Security tab > Protocol . 2. Configure each item. 3. Click Next . 4. Click OK . The settings are applied to the scanner. Related Information & “Running Web Config on a Web Browser” on page 26 Protocols you can Enable or Disable Protocol Setting Items Bonjour Settings 210 Protocol Description Bonjour Settings You can specify whether to use Bonjour. Bonjour is used to search for devices, scan, and so on. SLP Settings You can enable or disable the SLP function.
SLP is used for push scanning and network searching in EpsonNet Confgi . WSD Settings You can enable or disable the WSD function. When this is enabled, you can add WSD devices, and scan from the WSD port. LLTD Settings You can enable or disable the LLTD function. When this is enabled, it is displayed on the Windows network map. LLMNR Settings You can enable or disable the LLMNR function. When this is enabled, you can use name resolution without NetBIOS even if you cannot use DNS. SNMPv1/v2c Settings You can specify whether or not to enable SNMPv1/v2c. This is used to set up devices, monitoring, and so on. SNMPv3 Settings You can specify whether or not to enable SNMPv3.
This is used to set up encrypted devices, monitoring, etc. Items Setting value and Description Use Bonjour Select this to search for or use devices through Bonjour. Bonjour Name Displays the Bonjour name. Bonjour Service Name Displays the Bonjour service name. Location Displays the Bonjour location name.