Preparing to Scan over a Network > Configuring a Mail Server Connecting the Scanner to the Network If the scanner is not connected to the network, use the installer to connect the scanner to the network. You can use following method to start installer. ❏ Setting up from the website Access the following website, and then enter the product name. Go to Setup , and then start setting up. http://epson.sn Related Information & “Checking the Network Connection Status” on page 191 & “Connect the Scanner to the Network Manually” on page 195 Configuring a Mail Server Set the mail server from Web Config. When the scanner can send the email by setting the mail server, the following are possible.
❏ Transfers the scan results by using email ❏ Receives the email notification from the scanner Check below before setting up. ❏ The scanner is connected to the network that can access the mail server. ❏ Email setting information of the computer that uses the same mail server as the scanner. Note: ❏ When you use the mail server on the Internet, confirm the setting information from the provider or website. ❏ You can also set the mail server from the control panel. Access as below. Settings > Network Settings > Advanced > Email Server > Server Settings 1. Access Web Config and select the Network tab > Email Server > Basic . 2. Enter a value for each item. 3. Select OK .
The settings you have selected are displayed. When the setup completes, perform the connection check. Related Information & “Running Web Config on a Web Browser” on page 26 69