Motor Note You might find it easier to remove the ECU pan (see page 164) before you remove the motor. 1 Separate the scanner from the printer (see pages 113 through 118) and remove the left side door and back cover (pages 129 and 130). 2 Remove the fuser assembly (see page 144). 3 Disconnect the motor cable connector (callout 1) on the side of the motor. 4 Remove the two screws (callout 2) from the motor and remove the motor. 2 2 2 1 Figure 68. Removing the motor To reinstall Make sure that the motor is in the correct position. The connector should face the inside of the printer. 150 Chapter 5 - Removal and replacement EN