16 en Drink preparation with milk The appliance must be ready for use. Preparing milk froth and warm milk ● ●Place the suction pipe 10d of the milk frother 10 deep in the milk container 26 . ● ●Swivel the coffee outlet 9 to the right until it clicks into place. ● ●Place the pre-warmed cup or glass under the coffee outlet 9 and milk frother 10 . ● ●Select the required Caffe Latte Д (only TES807), Macchiato Е , Cappuccino Ж or My coffee З (only TES807) by turn- ing the rotary knob 6 . ● ●Open the powder compartment 18 . ● ●Pour in no more than 2 level measuring spoons 14 of ground coffee. Ў Ў Risk of burns! The milk frother 10 gets very hot.
After use, allow to cool down first before touching. The appliance must be ready for use. ● ●Place the suction pipe 10d of the milk frother 10 deep in the milk container 26 . ● ●Place the pre-warmed cup or glass under the outlet of the milk frother 10 . ● ●Select the required setting Milk froth И or Warm milk Й by turning the rotary knob 6 . ● ●Press the start button 8 . Milk froth or warm milk flows from the outlet of the milk frother 10 . Ў Ў Warning! Do not use whole beans or instant coffee. ● ●Close the powder compartment 18 . ● ●Press the start button 8 . First milk is delivered into the cup or glass. Then the coffee is brewed and dispensed into the cup or glass.
Press the start button 8 again to cut the process short. Info: When preparing warm milk, you may hear a whistling sound. This is caused by the milk frother 10 for technical reasons. Important: Dried milk residue is difficult to remove, so the milk frother 10 must be cleaned with lukewarm water immediately after use (see “Cleaning the milk system”). Tip: For optimal milk froth quality, use cold milk with a fat content of at least 1.5 % if possible. Note: Repeat the procedure for another cup of coffee / milk drink. If coffee is not dispensed within 90 seconds, the brewing chamber empties automatically to avoid an overflow. The appliance rinses. Important:
Dried milk residue is difficult to remove, so the milk frother 10 must be cleaned with lukewarm water immediately after use (see “Cleaning the milk system”). Robert Bosch Hausgerдte GmbH TES803_805_807_1RW.indb 16 08.05.2013 14:52:59