Roll Paper Compatible paper formats are as follows. • Continuous paper (black marks) • Die-cut labels (black marks) • Die-cut labels (gaps) • Die-cut labels with transparent backing paper Paper Handling Method • Continuous paper (black marks) Set the leading edge of the first black mark so that it is located at 172.5 to 200 mm from the leading edge of the paper. Do not set the black mark so that it is located at less than 172.5 mm from the leading edge of the paper. • Die-cut labels (black marks and gaps) and die-cut labels (gaps) with transparent backing paper Set the leading edge of the first label so that it is located at 172.5 to 200 mm from the leading edge of the paper.
Do not set the label or black mark so that it is located at less than 172.5 mm from the leading edge of the paper. This area must only consist of backing paper. Black mark width leading edge Paper feed direction 172.5 to 200 mm 85 Black mark width leading edge Paper feed direction 172.5 to 200 mm