Roll Paper Handling Paper formats that can be handled are as follows. • Continuous paper (black marks) • Die-cut labels (black marks) • Die-cut labels (gaps) • Die-cut labels with transparent backing paper Paper Handling Procedures • Continuous paper (black marks) and die-cut labels (black marks) Set a margin of 107.5 mm or more between the end edge of the paper and the end edge of the final ticket or label printed. Do not set the label so that it is located less than 107.5 mm from the end edge of the paper. This area must only consist of backing paper. Affix two black marks behind the final ticket or label printed.
Continuous paper (black marks) Roll paper core Die-cut labels (black marks) Paper feed direction Max. 11 mm End edge of last label Roll paper core 5 ±0.5 mm 107.5 mm or more 88 Q NOTE If new print data is sent to this printer after print processing (including auto cut) of the final ticket or label has completed normally, a Media Size Error will occur, and the printer will stop with the print data retained. Paper feed direction Max. 11 mm 5 ±0.5 mm 107.5 mm or more Max. 11 mm 5 ±0.5 mm 107.5 mm or more