Media arrangement Roll paper This can be used with the following media forms. • Continuous paper (Blackmark) • Die-cut label (Blackmark) • Die-cut label (Gap) • Transparent die-cut label Loading Paper When feeding paper, bring the edge of the roll paper between the autocutting position and the edge of the paper ejection table, then close the roll paper cover. Area for the edge of the paper Autocutting position Head Edge of the paper ejection table Edge of the paper Method for arranging the media • Continuous paper (Blackmark) Place the edge of the first black mark in a position 172.5 mm {6.791”} or more from the edge of the roll paper, and do not place a black mark before there.
• Die-cut label (Blackmark), die-cut label (gap), and transparent die-cut label Place the edge of the first label in a position 172.5 mm {6.791”} or more from the edge of the roll paper, and do not place a label or black mark before there, leaving only the backing. Label edge Paper feed direction 172.5 mm {6.791” } or more 160 Media arrangement when feeding media for printing from the first sheet Black mark position Paper feed direction 172.5 mm {6.791” } or more