TM-P60 Technical Reference Guide 2.5.5.1 Connecting the external power supply 1. Turn off the printer. 2. Connect the external power supply into the connector as shown following figure. connector for the external power supply (It is covered by a cap) Connect the external power supply here after opening the cap WARNING: Make sure you use the EPSON PS-10 AC adapter or LPS power supply. Using an incorrect external power supply may cause fire or electrical shock. Note: Never disconnect the external power supply while printing, even if the battery pack is connected. If the battery level quickly returns to “Level L” even after recharging, the end of the battery life has been reached.
Replace with a new battery. Never remove the battery pack or disconnect the external power supply while printing. Rev. A Setup 2-11