Error signal output Enabled (initial setting) Disabled Paper position immediately after the specific state Specific state: after the roll paper cover is closed, the printer is reset, or the power is turned on. Function Select Enabled Disabled (initial setting) Position Select Cut Position Top Position (initial setting) USB class Printer Class Vendor Class (initial setting) Bluetooth interface Passkey (initial setting: 0000) Device name (initial setting: TM-P80_xxxxxx) Security (initial setting: Low) Auto Re-Connect with iOS device (initial setting: Enabled) The device name is initially set to TM-P80_xxxxxx.
(xxxxxx refers to the last 6 digits of the serial number labeled on the back of your printer.) When the firmware version is 6.14 ESC/POS or later, you can change the Bluetooth security settings. (iOS Bluetooth model only) Acceptable Characters 54 Item Number of characters Acceptable Characters Passkey 4 to 16 30H to 39H, 41H to 46H (Indicates the number from “0” to “9” and “A” to “F” in hexadecimal) Device Name 1 to 31 20H, 21H, 23H to 7EH (Character code between 20H and 7EH and except for the double quotation mark ("))