Chapter 2 Setup Connecting the Optional External Buzzer When the optional external buzzer (model: OT-BZ20) is connected to the drawer kick connector of the printer, you can set the printer so that it beeps when you send commands, when an error occurs, when executed auto cutting, and when detected paper end. Settings for sound patterns and frequency depending on the occasions the buzzer beeps are also available. Use the TM-T100 Utility to make the buzzer settings: enable/disable setting, sound pattern setting, and frequency setting. Be sure to turn off the printer before you connect/disconnect the optional external buzzer.
The optional external buzzer and the cash drawer cannot be used simultaneously. Do not connect both the optional external buzzer and the cash drawer to the printer at the same time by using a branched connector. Volume adjustment knob The optional external buzzer is recommended to be installed in the following positions. Do not install the optional external buzzer at the roll paper exit. To prevent liquid from entering inside, it is recommended to install the optional external buzzer so that the volume adjustment knob is positioned sideways or downward. 25 Connecting Procedure