18 The dialog shown on the right will be displayed, select [Internet protocol version 4 (TCP/IPv4) and open the property. The dialog shown on the right will be displayed, set the IP address and the subnet mask for the PC so that the IP address and network part of the referred robot controller are the same, but the host part is different. *Example: Robot controller:10.5.5.101 PC :10.5.5.110 3 Launch WINCAPS III. 4 Set the User level and log in. From the [File] Menu, select [New Project]. The New Project Wizard will be displayed. Follow the wizard to make various settings and create a project. This section describes how to make settings for the selection [Get information from the 5