Atari Games · Final Lap · 2 стр.
Atari Games Final Lap Spring Replacement Procedure — Arcade Service Manual PDF (EN)
Оригинальное название: Atari Games Final Lap Spring Replacement Procedure — Arcade Service Manual PDF
Похожие инструкции
Содержание
Текст документа
Final Lap Spring Replacement Procedure_Page_1.jpg
Al ATARI GAWMWES Final Lap This Procedure can shaft on the Final bumper stop at 1. Open the assembly 2. Remove Spring Replacement be used to replace the Lap steering assembly. this time as control panel and disconnect the harness, remove (4) button head (7) 1/4-20 button head to gain screws. Remove steering (6) to spring and/or the Have a look at the well. vacu-formed bezel assembly mounting nuts Procedure 1/4-20 gain access Remove steering Remove (4) to access spring torm head to assembly the assembly phillips screws the screws steering screws. and nuts of the steering mounting stops. screws mounting control from the the and screws. panel. two spring stops.
Remove the the end of 1/4-20 cap the shaft. Kemove tne (2) spacers from anda screws and and gear from and (2) catcn, shaft. large a rag Slide steering spring. to remove and replace the the insides and thrust surfaces and klip ring. Lube with 11. Replace the 12. Install large 13. Align shaft back bronze bearings a light oil. Install bottom 15. nuts washers, Remove the klip ring and Cover the klip ring with 10. 14. 8-32 the screw, Replace stop (2) up, (2) on diameter washer. during removal. SAFETY: shaft. diameter of x to opposite shaft 8-32 on washer 1 either new longer 3/8 side bumper stop cap screws, (longer) of spacers of spring. over cap screws. housing. from
Final Lap Spring Replacement Procedure_Page_2.jpg
16. Place catch over closest to facing the 17. Thread in 18.* THIS THE IS the the spring the the other cap screw HARD 8-32 19\.¥ side Now on wheel the cap screw with the half that is moon cutout tang. partway. PART: around the shaft steering wheel), cutout. spacer steering Pull the other spring tang in a clockwise direction (facing pre-loading the spring until it of the catch and nested push the catch over and the is on in the half onto the remaining moon capscrew. Thread in this cap screw then tighten both to 28 +-5 in. lbs. 20. IMPORTANT:
Be sure to lube the spring with a heavy lubricant (axle grease, white grease, Vaseline, nyogel, silicon grease) on the inside, outside, between the coils, and at each tang where it is nests in the half 21. moon cutout. Install both spring stops head screws so that: 1) The shaft should stop just is cover with the (4) 8-32 opposite the bumper the 3/16 diameter 1/4-20 cap phillips stop hole (it in the end of housing). 22. Install gear, shaft, DO NOT washers, and TIGHTEN YET! 23 IMPORTANT: Be sure to align the set screw is pointing down (toward the center of the steering wheel is centered. on the end of the and feel right now. harness), Now tighten shaft.
and the the 1/4-20 cap should now work pot screw Steering wheel Inspect the bumper stop 25. Replace the (6) 1/4-20 steering 26. Replace the (7) 1/4-20 bezel ATs Reconnect 28. Close and secure head screws. 24. steering screw gear on so that the solder lug NOTE: now. assembly mounting mounting bolts. bolts. harness. the control panel with the (4) button