Atari · Mini-Track Ball · 1 стр.
Atari Mini-Track Ball Technical Bulletin — Service Manual PDF (EN)
Оригинальное название: Atari Mini-Track Ball Technical Bulletin — Service Manual PDF
Похожие инструкции
Текст документа
Coin Operated Games Division September Atari Incorporated 18,198] 1265 Borregas Avenue PO Box 427 Sunnyvale California 94086 408 745 2000 TO: All Distributors Attention: Service Managers Parts Managers Sales Managers There appears its solution. to be a misunderstanding First on the mini-track of all, ball PCB. the as problem The Atari to the mini-track is a marginal solutions problem coupler Qn the Logic PCB, the and R130 to R133 were 2. The generation of an A-035220-02 version of the mini-track This is a selected PCB to be used with the Centipede games through Rev »F Logic: PCB's. The -01 manufacturing of a Rev or -02 versions of the and component been: 1. 3.
value of the reduced from have ball optical input track ball 10K ohms to 3.3k G logic PCB which can be mini-track ball PCB's. resistors ohms. used R83 to R86 ball PCB. using Rev with either NOTE: input In order for the -02 versions to function properly, make certain the track ball resistors on the logic PCB's are 3.3k ohms. Some older games may still have the 10k ohm resistors. Some individuals in the field are changing the input track ball resistor values to match the mini-track ball PCB. This may be a temporary fix for the specific track ball PCB being used.
However, if a -02 version is later used, the input track A ball resistors on the Any comment or questions on contact your Atari Regional Thank You, Atari Field logic board this matter Manager. should will be be changed to 3.3k ohms. greatly appreciated. Please Service ® A Warner Communication Comoany