Komatsu PC4000-6 Hydraulic Mining Shovel Manual (EN)

COVER

OMPC 4 000 8172 Operation & Maintenance Manual PC4000-6 HYDRAULIC MINING SHOVEL SERIAL NUMBERS PC 4 000 -6 8172 This material is proprietary to Komatsu Mining Germany GmbH and is not to be reproduced, used, or disclosed except in accordance with written authorization from Komatsu Mining Germany GmbH . It is our policy to improve our products whenever it is possible and practical to do so. We reserve the right to make changes or improvements at any time without incurring any obligation to install such changes on products sold previously. Due to this continuous program of research and development, revisions may be made to this publication.

It is recommended that customers contact their distributor for information on the latest revision. Copyright 2006 Komatsu Printed in U.S.A. Komatsu Mining Germany December 2006

Стр. 1

1. INTRODUCTION

1. INTRODUCTION 3

Стр. 3

1.1 CONTENTS OF THE BINDER

1.1 CONTENTS OF THE BINDER INTRODUCTION 1.1 CONTENTS OF THE BINDER Assembled in this file are the Operation- and Maintenance Manu- als for your KOMATSU Mining Shovel. 4

Стр. 4

1.2 DIVISION OF THE BINDER

INTRODUCTION 1.2 DIVISION OF THE BINDER 1.2 DIVISION OF THE BINDER Part 1: Operation Manual Part 2: Maintenance Manual Part 3: Depending on the volume of Part 3 a second Binder "Volume 2" is being delivered with the Shovel. This Binder contains the General Assembly Procedure Manual for the Shovel, Specification Book- let, Service Literature for the Power Unit (Diesel Engine or Elec- tric Motor) and for Special Equipment. The Electrical- and Hydraulic Diagrams are attached in the pocket of the front cover. Refer to the -TABLE OF CONTENTS VOLUME 2 BINDER- for details. Read the Manuals before You Start the Engine.

Before operating the machine, familiarize yourself with its instru- ments and controls. Observe the instructions in these manuals for: your Personal SAFETY Operating SAFETY, and READY and EFFICIENT PERFORMANCE of your KOMATSU Shovel. Periodic preventive inspections and maintenance are the surest means of keeping the machine in proper working order. Prompt detection and correction of minor irregularities, and immediate replacement of worn out or broken parts will prevent failures and avoid expenses. Replace damaged graphics and symbols. Observe safety precautions to prevent injury and damage.

If you have any questions concerning this literature please con- tact Komatsu Mining Germany GmbH Service Information Department 8151.30 P.O. Box 18 03 61 D - 40570 Dьsseldorf GERMANY 5

Стр. 5