HMI-WPL-Instruction-Manual (EN)

Table of Contents

Table of Contents | DOP-EXIO Series Table of Contents Chapter 1 Getting Started .........................................................................................1-1 Chapter 2 HMI-WPLSoft Introduction........................................................................2-1 Chapter 3 Creating and Editing Programs ................................................................3-1 Chapter 4 I/O Point Indicators...................................................................................4-1 Chapter 5 Internal Memory Address .........................................................................5-1 Appendix A List of Devices.........................................................................................

A-1 Appendix B List of Instructions ................................................................................... B-1 Appendix C Use of Basic Instructions......................................................................... C-1 Appendix D Use of Application Instructions ................................................................ D-1 Revision March, 2008, Doc. Name: 2007PDD23000014 i

Стр. 2

Table of Contents

Table of Contents | DOP-EXIO Series This page intentionally left blank. ii Revision March, 2008, Doc. Name: 2007PDD23000014

Стр. 3

Chapter 1 Getting Started

Chapter 1 Getting Started | DOP-EXIO Series Chapter 1 Getting Started Delta Extension Digital I/O Module, DOP-EXIO14RAE and DOP-EXIO28RAE (hereinafter called “DOP-EXIO series”) provided for DOP-AE series HMI only. Therefore, before using Delta Extension Digital I/O Module, the user has to open the ScrEdit (Screen Editor) programming software, click “File” > “New” to open a new project, and select the type of DOP-AE series HMI being used (see Fig. 1.1). Fig. 1.1 New project dialog box After selecting the type of DOP-AE series HMI, press OK button to complet the setting. Then, click “Options > “Configuration” to enter into “Other” tab in Configuration option (see Fig. 1.2).

Check the box next to “Enable EXIO (Compile Ladder)” to activate the function of Delta Extension Digital I/O Module. The user can also select the digital input and output points here by using the drop down list right below the “Enable EXIO (Compile Ladder)” option (see Fig. 1.3). Revision March, 2008, Doc. Name: 2007PDD23000014 1-1

Стр. 4

Chapter 1 Getting Started

Chapter 1 Getting Started | DOP-EXIO Series Fig. 1.3 Other tab When “Enable EXIO (Compile Ladder)” option is selected, the “Ladder Editor” icon will appear and be available for use on the toolbar (See Fig. 1.4 and 1.5). The user can click this icon and start ladder diagram editing directly or click “Tool” > “Ladder Editor” command from the menu (See Fig. 1.6). Fig. 1.4 Toolbar before “Enable EXIO (Compile Ladder)” option is selected Fig. 1.5 Toolbar after “Enable EXIO (Compile Ladder)” option is selected Revision March, 2008, Doc. Name: 2007PDD23000014 1-3

Стр. 6