7 ． EtherNet/IP Connection Procedure 7. EtherNet/IP Connection Procedure This section describes the procedure for connecting the FZ5 Sensor Controller to the Controller via EtherNet/IP using the "Procedure for Using the Configuration Files". This document explains the procedures for setting up the Controller and the FZ5 Sensor Controller from the factory default setting. For the initialization, refer to Section 8 Initialization Method . ■ Setting Overview The following figure shows the relationship of operating the EtherNet/IP tag data link using the "Procedure for Using the Configuration Files".
Configuration Files Sysmac Studio project file Network Configurator v3 network configuration file Opening the project file Opening the network configuration file Personal computer Sysmac Studio Network Configurator Transferring the Project Data Transferring the Tag Data Link Parameters Controller Destination Device Precautions for Correct Use Prepare the latest "Sysmac Studio project file" and "Network Configurator v3 network (To obtain the files, contact your OMRON representative.) configuration file" from OMRON in advance. 12