7 ． EtherNet/IP Connection Procedure 7.1. Work Flow Take the following steps to operate the tag data link for EtherNet/IP. Set up the FZ5 Sensor Controller. ↓ 7.2.1. Parameter Settings Set the parameters for the FZ5 Sensor Controller. ↓ Set up the Controller. ↓ 7.3.1. Starting the Sysmac Studio and Start the Sysmac Studio and import the Sysmac Studio project file. Importing the Project File ↓ 7.3.2. Connecting Online and Connect online with the Sysmac Studio and transfer the project data to the Controller. Transferring the Project Data ↓ Set the tag data links for the EtherNet/IP. ↓ 7.4.1.
Starting the Network Start up the Network Configurator and open the Network Configurator v3 network configuration file. Configurator and Opening the Network Configuration File. ↓ 7.4.2. Transferring the Tag Data Link Transfer the tag data link parameters to the Controller. Parameters ↓ Confirm that the EtherNet/IP tag data links are operated normally. ↓ 7.5.1 Checking the Connection Status Check the connection status of EtherNet/IP. ↓ 7.5.2 Checking the Data that are Sent Confirm that the correct data are sent and received. and Received 13 7.2. Setting Up the FZ5 Sensor Controller 7.3. Setting Up the Controller 7.4. Setting Up the Network 7.5. Checking the EtherNet/IP Communications