Текст документа
Preparation Please read entire manual before installation. Before You Start • Disconnect negative battery terminal. Consult a qualified technician for instructions. • Avoid installing the unit where it would be subject to high temperatures, such as from direct sunlight, or where it would be subject to dust, dirt or excessive vibration. Getting Started • Remove trim ring from unit. • Remove 2 transit screws located on top of the unit. • Insert the supplied keys into the slots as shown, and slide the unit out of the mounting sleeve. • Install mounting sleeve into opening, bending tabs to secure. • Connect wiring harness and antenna. Consult a qualified technician if you are unsure.
• Certain vehicles may require an installation kit and/or wiring harness adapter (sold separately). • Test for correct operation and slide into mounting sleeve to secure. • Snap trim ring into place. MOUNTING SLEEVE REMOVAL KEYS HEAD UNIT INSTALLATION MOUNTING KITS OR DASHBOARD TYPICAL FRONT-LOAD DIN MOUNTING METHOD 2 DC505iBT INSTALLATION
Стр. 2
DC505iBT INSTALLATION Wiring Diagram Antenna Connector 10 AMP AGC Fuse FUSE When replacing the fuse, make sure new fuse is the correct type and amperage. Using an incorrect fuse could damage the radio. The DC505iBT uses one 10 amp ATM fuse located beside the wiring connector. 3
Стр. 3
DC505iBT OPERATION Control Locations - Receiver 1 2 3 4 7 19 18 17 15 16 14 8 9 10 11 12 13 Release Preset 4 / Play / Pause 1 2 Power / Mute 10 11 Preset 3 / Intro 3 Volume / Select 12 Preset 2 / Random 4 Audio / Menu 13 Preset 1 / Repeat 5 USB Port 14 Display 6 Eject 15 Tune / Track Up 7 8 Auxiliary Input Preset 6 / Folder Up / Thumbs Up 16 17 Tune / Track Down Band / Go Back 9 Preset 5 / Folder Down / Thumbs Down 18 Mode 19 Bluetooth Talk 4 5 6
Стр. 4
DC505iBT OPERATION General Operation 5 Power On/Off Mode Auxiliary Input Volume Display Reset Set the Clock 12/24-hour Clock Setup Menu Press or any other button (except EJECT) to turn the unit on. Press to turn the unit off. Press MODE to select between AM/FM, CD player, auxiliary front/rear, USB, operation of iPod®/iPhone® and Bluetooth. Modes of operation are shown in the display. NOTE: CD, USB and operation of iPod modes will not appear unless a CD is inserted or USB/iPod devices are connected. The DC505iBT offers a 3.5 mm port on the front panel to connect audio device, MP3 player, etc. Press MODE to select AUX mode. Adjust volume using volume knob (00-30).
Press DISP to select between clock and different types of information, such as radio frequency, CD track/elapsed time or MP3/WMA song information. Press RESET upon initial installation or if abnormal operation occurs. Reset button is located behind the front panel. With the unit on, press and hold DISP until the clock begins to flash, then release. Press TUNE nn to adjust the hours and TUNE ll to adjust the minutes. Press DISP momen- tarily to save the selected time. The clock will display 12-hour AM/PM time in USA frequenc spacing mode (PM 10:00). In European frequency spacing mode, the clock will display 24-hour time (22:00).
Press and hold AUDIO/MENU for more than 3 seconds to access the setup menu. Press AUDIO/MENU momentarily to select between the menu functions and rotate the volume knob left/right to adjust or activate the desired function.
Стр. 5