Victron SmartSolar Control Display Manual: User & Service Guide PDF (EN)

Table of Contents

SmartSolar Control display manual Table of Contents 1. Introduction ........................................................................................................................... 1 2. Installation ............................................................................................................................. 2 3. Operation .............................................................................................................................. 3 3.1. Status menu .................................................................................................................. 4 3.2.

History menu ................................................................................................................. 5 3.3. Setup menu .................................................................................................................. 7 4. Troubleshooting and Support ................................................................................................... 12 4.1. The display does not power up .......................................................................................... 12 4.2. The display segments are faint or missing ............................................................................. 12 4.3.

Display keeps scrolling through different menu items ................................................................. 12 4.4. Settings locked ............................................................................................................ 12 5. Warranty ............................................................................................................................. 13 6. Specifications ....................................................................................................................... 14

Стр. 2

1. Introduction

SmartSolar Control display manual 1. Introduction The SmartSolar Control display is a dedicated display for the following MPPT solar charger ranges: SmartSolar MPPT 150/45 up to 250/100 SmartSolar MPPT 150/70 up to 250/100 VE.Can BlueSolar MPPT 150/70 up to 250/100 VE.Can These solar chargers can also be recognised by a small plastic cover on the front face with the text "display option". Example of a solar charger without display and with display The display plugs directly into the front face of the solar charger. It can act as both a permanent or a temporary display.

Simply remove the plastic cover that protects the display terminal on the front of the controller and then plug in the display. The display can be used to monitor the solar charger and to view both live and historic data. The display can also be used to configure solar charger settings. Examples of live and historic monitoring: PV power, yield, voltage and current. Battery voltage, current and charge stage. Load output state and current (only available if the solar charger is equipped with a load output). 30-day historical values. Cumulative historic values over the live of the solar charger. Page 1 Introduction

Стр. 3

2. Installation

SmartSolar Control display manual 2. Installation The display connects to the display terminal on the front of the solar charger. The display terminal is located behind the plastic cover with the text: "display option". To install the SmartSolar Control display do the following: 1. Remove the two screws of the plastic cover. Keep the screws, they are needed again when securing the display. 2. Remove the plastic cover. The display terminal is now exposed. 3. Remove the two plastic plugs on either side of the display plug. 4. Remove the paper backing of the double sided tape on the back of the display. 5. Insert the display into the plug and make sure it has been inserted all the way in. 6.

Screw the display down by using the two screws that were used for the plastic cover. How and where to connect the SmartSolar Control display If the display is used as a temporary display, it is not necessary to use the tape and to screw down the display into the solar charger. The display is hot-swappable, this means that the display can be plugged in or removed while the solar charger is operating. Page 2 Installation

Стр. 4

3. Operation

SmartSolar Control display manual 3. Operation The LCD screen displays the following information: A number reading. The unit of the reading: V, A, W, kWh, h or °C/°F. The type of reading: battery, PV or temperature. State: charge and charge stage indication. Connection indicator and warning indicator. Full LCD readout The digits used to represent letters and numbers The buttons on the front of the display are used to navigate through the solar charger readings and are used when making solar controller and display settings.They have the following functions: Page 3 Operation Button Action Cancel or Back Select or Conform Go to next or previous ite or Increase or decrease val

Стр. 5