HOME 2.20 HANDLEBARS: VRSCDX REMOVAL 1. Loosen headlamp adjuster and lower headlamp/nacelle assembly to allow for procedure. See 1.27 HEADLAMP ALIGNMENT . sm02172 2. Remove right side cover and maxi-fuse. See 7.4 MAXI- FUSE . 3. Remove rear view mirrors and turn signals. 4. Remove throttle cables from throttle control. See 2.10 THROTTLE CABLES . 5. Remove front brake master cylinder/reservoir, turn signal assembly, and throttle control from right handlebar. See 2.15 FRONT BRAKE MASTER CYLINDER/RESERVOIR . 6. Remove switch housing from right handlebar. See 7.30 RIGHT HANDLEBAR SWITCH . 7. Cut clip holding wiring harness to right handlebar. 8.
Remove clutch master cylinder/reservoir, turn signal assembly from left handlebar. See 2.11 CLUTCH MASTER CYLINDER AND RESERVOIR . Figure 2-46. Handlebar Top Clamp Fasteners (typical) 9. Remove switch housing from left handlebar. See 7.31 LEFT HANDLEBAR SWITCH . 10. 11. 12. See 13. 14. 15. (4). Figure 2-47.Top Clamp, Handlebar, and Riser (typical) lip holding wiring harness to left handlebar. ove the instrument cluster from the handlebar top p. See 7.21 INSTRUMENT CLUSTER: VRSCDX. Figure 2-47. Supporting the handlebars (3), loosen emove the 4 fasteners (1) holding the top clamp (2). ove the handlebars (3). cessary, remove the handgrip.
cessary, loosen and remove the two fasteners (5) ring riser (4) to upper fork clamp and remove the riser bar top DX. loosen mp (2). sm02173 2 1 3 4 5 1. Top clamp fastener 2. Top clamp 3. Handlebar 4. Riser 5. Fastener INSTALLATION 1. Install cast riser on upper triple to 41-47 Nm (31-35 ft-lbs). 2. Mount handlebar on riser with tighten fasteners to hold handle e: Chassis clamp. Tighten fasteners top clamp. Thread in and bar. 1-47 Nm (31-35 ft-l