HOME sm03654 Be sure to follow manufacturer's instructions when using propane torches. Failure to follow manufacturer's instructions can cause a fire, which could result in death or serious injury. (00465c) When applying heat to the clutch hub mainshaft nut, do so carefully. Excessive heat will damage pressure plate springs. NOTE 9. Heat clutch hub nut with a propane torch to loosen LOC- TITE. If necessary, an air impact can be used (REMOVAL ONLY) to remove nut. 10. See Figure 6-8 . Remove clutch hub nut. NOTE CLUTCH HUB NUT (Part No. HD-8008M) is one-time-use only. Always use a new nut for assembly. Figure 6-9. Remove Clutch Assembly 11. Remove CLUTCH HUB HOLDER (Part No. HD-48625).
DISASSEMBLY Figure 6-8. Remove Clutch Hub Nut 1. Remove clutch pack from clutch basket. 2. See Figure 6-11 . To prevent breaking lifter plate, slowly loosen (2-3 turns at a time) fasteners in a crisscross pat- tern. 3. See Figure 6-12 . Remove clutch springs and measure clutch spring free length. 4. Replace clutch springs if free length is less than 42 mm (1.65 in). 5. Slide hub from the clutch plate. Remove friction plates and steel plates for inspection. 2009 VRSC Service: Transmission 6-5 12. See Figure 6-9. Remove clutch assembly. sm03 13. See Figure 6-10. Note position of thrust washer behind the clutch basket. sm03645 884 Figure 6-10.Thrust Washer Position