HOME sm03660 2. Check friction plates as follows: a. Blow off all lubricant from the friction plates . Do not wipe off with a rag. b. Look for worn or damaged fiber surface material (both sides) c. Measure the thickness of each plate with a dial caliper or micrometer. d. If the thickness of any plate is less than 3.62 mm (0.142 in.), discard all friction plates and replace with an entirely new set. NOTE Replace all nine friction plates with an entirely new set if any individual plate shows evidence of wear or damage. Friction plates must be presoaked before installation. Figure 6-11. Lifter Plate Fasteners 3. Check the steel plates as follows: a.
Discard any plate that is grooved or bluish in color. Figure 6-12. Measure Clutch Spring Free Length 1. See Figure 6-13 . Slide steel damper spring with concave side up into position on spring seat on clutch outer hub. CLEANING AND INSPECTION sm03888 Compressed air can pierce the skin and flying debris from compressed air could cause serious eye injury. Wear safety glasses when working with compressed air. Never use your hand to check for air leaks or to determine air flow rates. (00061a) 2 1 1. Wash all parts in cleaning solvent, except for friction plates and bearing, if removed. Blow parts dry with low pressure compressed air. 1. Damper spring seat 2. Damper spring Figure 6-13.
Damper Spring Position 6-6 2009 VRSC Service: Transmission sm03887 b. Check each plate for distortion. Lay the plate on a precision flat surface. Insert a feeler gauge between the plate and the flat surface in several places. Replace any steel plate that is warped more than 0.15 mm (0.006 in.). 4. Holding the clutch hub, rotate the pressure plate to check bearing for smoothness. Replace the bearing if it runs rough, binds or has any end play. 5. Check ramps for excessive wear. Replace hub if ramps are worn or damaged. ASSEMBLY PART NUMBER TOOL NAME HD-45654 CLUTCH DISC ALIGNING SPACER TOOL NAME PART NUMBER HD-45654 CLUTCH DISC ALIGNING SPACER