2009 — Assembly

HOME • New plates should be soaked for 10 minutes in Harley- Davidson Motorcycle Oil 20W50 and assembled wet. NOTES sm04190 • Note different spacings in friction material on friction plates, as well as one larger inner-diameter steel plate. The closely spaced friction material plates go ONLY on the outboard positions during assembly. sm04191 Figure 6-16. Proper Stacking of Spacer and Friction Plates 4. See Figure 6-16 . Install large inside diameter steel plate on top friction plate previously installed on pressure plate, then a regular-spaced friction plate as shown. 5. Stack remaining plates on clutch hub; alternating friction plate, steel plate until all plates are in place. Figure 6-15.

Difference in Steel Plate Diameters 3. See Figure 6-15 . Note inside diameter difference on single steel plate. 2009 VRSC Service: Transmission 6-7 Figure 6-14. Friction Plate Material Spacing Difference (outboard plate shown on right) 2. See Figure 6-14. Install one closely-spaced friction material plate onto clutch hub, and one onto pressure plate. sm03666 sm04522 Figure 6-17. Assemble Clutch Hub and Pressure Plate 6. See Figure 6-17 Place assembled clutch hub on bench, and assembled pressure plate in hand, slowly mate clutch halves until fully seated and align plate tabs so clutch pack assembly can drop into clutch basket under it's own weight.