HOME sm03902 Figure 6-27. Clutch Basket Figure 6-29. Install Clutch Pack (typical) 4. See Figure 6-28 . Clutch basket will not go completely into position until the spring loaded backlash gear is aligned. NOTE 5. See Figure 6-29 shaft and outer hub. 6. See Figure 6-6 6-10 2009 VRSC Service: sm00883 1 in one position. The engine case dowel pin must match the hole in the tool. Rotate engine toward front cylinder only. Do not rotate engine toward rear cylinder, as engine damage can result. (00409c) 7. See Figure 6-7. If necessary, rotate engine slightly to properly engage the clutch hub. sm03903 1.
This side toward engine case Figure 6-26.Thrust Was her Position in in hole to align backlash gear. Clutch hub nut is one-time-use only assembly. e clutch pack into clutch housing. It rotate input shaft to align splines of 8. Install CLUTCH HUB HOLDER 9. Install a new clutch hub nut an tall CLUTCH HUB HOLDER (Part ft-lbs). lutch hub holder can only be installed e: Transmission . Always use a new nut for (Part No. HD-48625). d tighten to 220 Nm (162