HOME NOTE Install GASKET ALIGNMENT DOWELS (Part No. HD-45340) to aid in cover installation. Wear safety glasses or goggles when removing or installing retaining rings. Retaining rings can slip from the pliers and could be propelled with enough force to cause serious eye injury. (00312a) 14. See Figure 6-30 . Install clutch side crankcase cover. Tighten fasteners in sequence to 9.7 Nm (86 in-lbs ). 10. Install new clutch hub nut retaining ring. 15. Press secondary clutch actuator into its mounting flange on crankcase cover. Install fasteners and tighten to 10 Nm (88 in-lbs ). 11. Remove CLUTCH HUB HOLDER (Part No. HD-48625). 12. Install oil retaining ring. 16.
Install secondary clutch actuator cover. Tighten to 6-10 Nm (53-88 in-lbs ). 13. Install lifter guide and retaining ring. sm03886 7 10 2 3 6 11 13 14 5 12 9 4 1 8 Figure 6-30. Clutch Side Crankcase Cover Torque Sequence @ 9.7 Nm (86 in-lbs) 2009 VRSC Service: Transmission 6-11