2009 — 480 Metri-Pack Connector Repair

HOME A.13 PACKARD 480 METRI-PACK CONNECTORS 480 METRI-PACK CONNECTOR REPAIR 3. Verify that terminal will not back out of the chamber. A slight tug on the cable will confirm that it is locked. General A 480 Metri-Pack (P.E.D.) connector is frequently used for the B+ (battery voltage) connector to power P&A accessories. 4. Rotate the hinged secondary lock inward until latches fully engage tabs on both sides of connector housing. Referred to as Packard connectors, Metri-Pack connectors are embossed with the initials P.E.D. NOTE If removed, install new anchored cable strap in O.E. location.

Tighten cable strap to capture conduit of both accessory con- nector and B+ connector approximately 25.4 mm (1.0 in.) from housings. See Figure A-42 . An AFL housing (5) is used on many igni- tion/light switches. The secondary lock (4) must be opened before removing the terminal from the housing. See 1. 2. 3. 4. 5. 1. 2. in place. Figure A-42. 480 Metri-Pack Connector: Remove Socket Terminal A-26 2009 VRSC Service: Appendix A Connector Repair parating Pin and Socket Housings NOTE any cable strap anchoring the wire conduits of the pin essory connector housing) and the socket (B+) housing. Figure A-42.

Using small flat blade screwdriver, press n (1) on pin housing (red wire) side of the connector and apart the pin and socket housings. ting Pin and Socket Housings nt the latch on the socket housing to the button catch on in housing and press the housings together. moving Socket Terminals See Figure A-42. Bend back the latch (2) slightly and free one side of secondary lock, then repeat to release the opposite side. Rotate the secondary lock outward on hinge to access terminal in chamber of connector housing. On the mating end of the connector, note the tang in the square shaped opening centered next to the terminal.

Gently insert the point of a stick pin or large safety pin into the opening (3) between the tang and the chamber wall until it stops. Pivot the end of the pin toward the terminal body to press the tang. Remove the pin and then pull terminal out of the wire end of connector housing. If necessary, crimp new terminals on wires. See A.15 PACKARD METRI-PACK TERMINALS. talling Socket Terminals Carefully bend the tang outward away from the terminal body. With the tang on the same side as the square shaped opening in the mating end of the connector housing, feed terminal into wire end of connector housing until it "clicks" sm00031a 1 2 3 4 5 1. Button on pin housing 2. Secondary lock latch 3.

Opening between tang and chamber wall 4. Secondary Lock (shown open) 5. AFL housing