2009 — 630 Metri-Pack Connector Repair

HOME A.14 PACKARD 630 METRI-PACK CONNECTORS 630 METRI-PACK CONNECTOR REPAIR engages a rib in the chamber wall to lock the terminal in place. TOOL NAME PART NUMBER SNAP-ON PICK SNAP-ON TT600-3 3. Moving to the mating end of the connector, take note of the small opening on the chamber wall side of each ter- minal. General Referred to as Packard connectors, Metri-Pack 630 series connectors are embossed with the initials P.E.D. 4. Insert SNAP-ON PICK (Part No. SNAP-ON TT600-3) into opening until it stops. Pivot the end of the pick toward the terminal to depress the locking tang. Separating Pin and Socket Housings 5.

Remove the pick and gently tug on the wire to pull the terminal from the wire end of the connector. Repeat steps if the terminal is still locked in place. NOTE If necessary, remove connector from barbed anchor or other retaining device. 6. If necessary, crimp new terminals on wires. Refer to A.15 PACKARD METRI-PACK TERMINALS . Bend back the external latch slightly and separate pin and socket halves of the connector. Installing Socket Terminal Mating Pin and Socket Housings NOTE Orient the latch to the catch and push the pin and socket halves of the connector together until the latch "clicks".

Refer to the wiring diagrams to match wire lead colors to alpha characters molded into the secondary locks of each connector housing. NOTE 1. Using a thin flat blade, like that of a hobby knife, carefully bend the tang outward away from the terminal body. If removed, install connector on barbed anchor or other OE retaining device. Removing Socket Terminal 2. With the tang facing the chamber wall, push the lead into 1. 2. engage latches on both sides of connector. 2009 VRSC Service: Appendix A Connector Repair A-27 free one side of t unlatch the other ard on hinge to vi connector housin osite the crimp ta the chamber at the he sec- heard when the ter side. 3.

Gently tug on the w ew the locked in place and g. The 4. Rotate the hinged s ils and