2009 — Metri-Pack Terminal Crimps

HOME 1. See Figure A-44 . Identify the correct die for the insula- tion/seal crimp (2). sm00036 2. Position the insulation/seal crimp in the nest. Be sure the insulation/seal crimp tails are facing the forming jaws. 2 1 3. Squeeze handle of crimp tool until tightly closed. Tool automatically opens when the crimp is complete. Inspecting Crimps 1. See Figure A-44 . Inspect the wire core crimp (1).The tails should be folded in on the wire core without any distortion or excess wire strands. 2. Inspect the insulation (2) or seal (3) crimp.The tails of the terminal should be wrapped around the insulation without distortion. 3 1. Wire core crimp 2. Insulation crimp 3. Seal crimp Figure A-44.

Metri-Pack Connector: Inspect Core and Insulation/Seal Crimps 2009 VRSC Service: Appendix A Connector Repair A-29