Chapter 6: Advanced Chassis Setup SAS/SATA Drives A total of eight SAS or SATA drives may be housed in the SC745 chassis. The drive IDs are preconfigured as 0 through 7 in order from bottom to top (or from left to right if rackmounted). A bezel covers the drive area but does not need to be removed to access the drives; simply swing open the bezel. If you wish to remove the bezel piece, push on the three tabs on the inside of the left lip of the front chassis cover. Then slightly swing out the same (left) side of the cover – about Ѕ inch only.
Remove by pushing on the open side of the cover to remove it from the chassis (do not try to swing or pull it straight out after opening the left side). The drives are mounted in drive carriers to simplify their installation and removal from the chassis. These drives are hot-swappable, meaning they can be removed and installed without powering down the system. The carriers also work to promote proper airflow for the system. For this reason, even carriers without drives must remain in the server. Note: Your operating system must have RAID support to enable the hot-swap capability of the drives. Note: Enterprise level hard disk drives are recommended.
For information on recommended HDDs, visit the Supermicro Web site at http://www.supermicro.com/ products/nfo/storage.cfm. Removing a SAS/SATA Drive 1. To remove a carrier, first open the front bezel. 2. Push the release button located beside the drive LEDs. 3. Swing the handle fully out and then use it to pull the unit straight out. Figure 6-7. Removing a Drive Carrier 6-9