ProjectionMode ProjectionMode VPARAMETER 140 Projection mode used by the tool to detect edges. Figure: Projection Modes used by Arc Caliper and Arc Edge Caliper Syntax MicroV+ VPARAMETER (sequence_id, tool_id, 140, index_id, object_id) = value value = VPARAMETER (sequence_id, tool_id, 140, index_id, object_id) V+ VPARAMETER (sequence_id, tool_id, 140, index_id, object_id) $ip = value value = VPARAMETER ($ip, sequence_id, tool_id, 140, index_id, object_id) Type 0 or 1 Range ACE Reference Guide, 18317-000 Rev A Page 448 Value Projection Mode Description 0 hsProjectionAnnular Annular projection is used to find edges that are aligned with the median annulus, such as arcs on concentric circles.
1 hsProjectionRadial Radial projection is used to find edges aligned along radial projections, similar to the spokes of a wheel.