AH Motion Controller – Hardware Manual Motion Control Modules Input/Output data registers are automatically assigned to a motion control module through HWCONFIG in ISPSoft according to the number of registers which is defined for the motion control module. Note : The below diagram only shows the list of the modules and is not an actual configuration. _3 Network Modules Input/Output data registers are automatically assigned to a network module through HWCONFIG in ISPSoft according to the number of registers which is defined for the network module. Note : The below diagram only shows the list of the modules and is not an actual configuration. 3-10 02HC 2 input channels.
The input device range occupies 14 data registers, and the output device range occupies 2 data registers. 04HC 4 input channels. The input device range occupies 28 data registers, and the output device range occupies 4 data registers. 05PM No input registers and no output registers are assigned to it. Please refer to AH500 Motion Control Module Manual for more information about the parameter setting. 10PM No input registers and no output registers are assigned to it. Please refer to AH500 Motion Control Module Manual for more information about the parameter setting. 15PM No input registers and no output registers are assigned to it.
Please refer to AH500 Motion Control Module Manual for more information about the parameter setting. 20MC No input registers and no output registers are assigned to it. Please refer to AH500 Motion Control Module Manual for more information about the parameter setting.