Delta Electronics AH — DFB_GroupEnable

Chapter 3 Motion Control Instructions  Linear interpolation requires at least 2 axes, which can be continuous or discontinuous, to be specified between AxisNumOrder_1 and AxisNumOrder_6 .  Arc interpolation and G-code require at least 3 successive axis numbers to be specified starting from AxisNumOrder_1 to AxisNumOrder_3 . For G-code applications, you can refer to DFB_GroupGcodeRun instruction.  The setting range for axis number is between 1 and 32. The specified axis number should not be repeated among the inputs of AxisNumOrder_1 to AxisNumOrder_6.

 Troubleshooting - If an error occurs during the execution of the instruction or when the axis is in the state of “Errorstop”, Error will change to True and the axis will stop moving. You can refer to ErrorID (Error Code) to address the problem. - Information regarding error codes and indicators and the associated troubleshooting information are attached as Appendices for a quick reference. For the complete troubleshooting of the system, refer to AH Motion Controller – Operation Manual .  Programming Example 3_ You can use DFB_GroupEnable to set up the number of axes in a group based on the limit and requirements of the coordinated axes for the actual applications. 1.

If you want to use axis 1~ 4 to execute group motion for absolute positioning, firstly you need to set up the axis group by DFB_GroupEnable. 2. Set M100 to True to specify axis 1~4 to the axis group number 1. 3. When M101 changes to True, the enabling of group axes is completed, and the axis group will change its state from “Disabled” to “Standby”. Also, the designated axes in the group will change their state from “Standstill” to “Coordinated”. 4. After the axis group is enabled, you can use group number 1 to perform the absolute positioning with interpolation.  Supported Products - AH Motion Controller CPU: AHxxEMC-5A - AH series motion control modules: AHxxEMC-5A 3-273