Delta Electronics AH — 9.3.5. Others

AH Motion Controller – Operation Manual _9 9-60 Error Code Description Corrective action 16#8611 No memory card exists, or the memory card format is incorrect. The system cannot detect the memory card. Format the memory card and try again. 16#9A33 An error occurs when COM1 communicates with slave 19 by Modbus or PLC Link. 1. Check the communication setting between the connecting devices. 2. Check if the communication cable is damaged. 16#9A34 An error occurs when COM1 communicates with slave 20 by Modbus or PLC Link. 1. Check the communication setting between the connecting devices. 2. Check if the communication cable is damaged.

16#9A35 An error occurs when COM1 communicates with slave 21 by Modbus or PLC Link. 1. Check the communication setting between the connecting devices. 2. Check if the communication cable is damaged. 16#9A47 COM1 receives no response from slave 7 by Modbus or PLC Link. (SM1591) 1. Check the communication setting between the connecting devices. 2. Check if the communication cable is damaged. 16#9B01 An error occurs when the Modbus connection of COM2 is initialized. Reset the parameters of Modbus conection of COM2 in the HWCONFIG. 16#9B21 An error occurs when COM2 communicates with slave 1 by MODBUS. 1. Check the communication setting between the connecting devices. 2.

Check if the communication cable is damaged. 16#9B22 An error occurs when COM2 communicates with slave 2 by MODBUS. 1. Check the communication setting between the connecting devices. 2. Check if the communication cable is damaged. 16#9B23 An error occurs when COM2 communicates with slave 3 by MODBUS. 1. Check the communication setting between the connecting devices. 2. Check if the communication cable is damaged. 16#9B24 An error occurs when COM2 communicates with slave 4 by MODBUS. 1. Check the communication setting between the connecting devices. 2. Check if the communication cable is damaged. 16#9B25 An error occurs when COM2 communicates with slave 5 by MODBUS. 1.

Check the communication setting between the connecting devices. 2. Check if the communication cable is damaged. 16#9B26 An error occurs when COM2 communicates with slave 6 by MODBUS. 1. Check the communication setting between the connecting devices. 2. Check if the communication cable is damaged. 16#9B27 An error occurs when COM2 communicates with slave 7 by MODBUS. 1. Check the communication setting between the connecting devices. 2. Check if the communication cable is damaged.