AH500 Hardware Manual 5.9.3.3 IP Address Knobs The IP address of the AHRTU-ETHN-5A series can be set via the address knobs; the default address range is 192.168.1.x and x should be set from 00 to FF. 5.9.4 Wiring AHAADP01EF-5A/AHAADP02EF-5A 5.9.4.1 Connecting 100BASE-FX Fibers TX RX RX TX AHAADP01EF-5A AHAADP02EF-5A 5.9.4.2 Specifications for Cables SC, multimode fiber, 62.5/125 μm SC, multimode fiber, 50/125 μm 5.9.4.3 Installing AHAADP01EF-5A/AHAADP02EF-5A on a Backplane The connector of AHAADP01EF-5A must be connected to the lower extension port of a backplane. The connector of AHAADP02EF-5A must be connected to the upper extension port of a backplane.
5-62 Address Description 00 ~ 0xFD 1. Valid IP address: 192.168.1.x, x = 1 ~ FD, (1~253) 2. 0x00: set up via EIP Builder 0xFE Go to the firmware update mode 0xFF Restore to factory defaults and reboot to have the defaults to take effect.