Chapter 9 Troubleshooting 9-5 Error Description Remedy code 16#0067 The size of the PLC parameters restored exceeds the size of the PLC parameters of the CPU module. The error code is a warning code. 16#2000 There is no END in the program in the PLC. (SM5) 1. Compile the program again, and download the program again. 2. Reinstall ISPSoft, compile the program again, and download the program again. 16#2001 The program is incorrect. There is a syntax error. (SM5) Check the program, compile the program again, and download the program again. 16#2002 GOEND is used incorrectly. (SM5) Check the program, compile the program again, and download the program again.
16#2003 The devices used in the program exceed the range. (SM0/SM5) Check the program, compile the program again, and download the program again. 16#2004 The part of the program specified by the label used in CJ/JMP is incorrect, or the label is used repeatedly. (SM0/SM5) Check the program, compile the program again, and download the program again. 16#2005 The N value used in MC is not the same as the corresponding N value used in MCR, or the number of N values used in MC is not the same as the number of N values used in MCR. (SM5) Check the program, compile the program again, and download the program again.
16#2006 The N values used in MC do not start from 0, or the N values used in MC are not continuous. (SM5) Check the program, compile the program again, and download the program again. 16#2007 The operands used in ZRST are not used properly. (SM5) Check the program, compile the program again, and download the program again. 16#200A Invalid instruction (SM5) Check the program, compile the program again, and download the program again. 16#200B The operand n or the other constant operands exceed the range. (SM0/SM5) Check the program, compile the program again, and download the program again. 16#200C The operands overlap.
(SM0/SM5) Check the program, compile the program again, and download the program again. 16#200D An error occurs when the binary number is converted into the binary-coded decimal number. (SM0/SM5) Check the program, compile the program again, and download the program again. 16#200E The string does not end with 0x00. (SM0/SM5) Check the program, compile the program again, and download the program again. 16#200F The instruction does not support the modification by an index register. (SM5) Check the program, compile the program again, and download the program again. 16#2010 1. The instruction does not support the device. 2. Encoding error 3.
The instruction is a 16-bit instruction, but the constant operand is a 32-bit code. (SM5) Check the program, compile the program again, and download the program again. 16#2011 The number of operands is incorrect. (SM5) Check the program, compile the program again, and download the program again.