Mitsubishi — 9.1.6 Others

AH500 Hardware Manual 9-14 Error Description Remedy code 16#620B The remote communication port set in the UDP socket function is illegal. 1. Check the program and the related special data registers. 2. Set the Ethernet parameter for the CPU module in HWCONFIG again. 16#620C The device from which the data is sent in the UDP socket function is illegal. 1. Check the program and the related special data registers. 2. Set the Ethernet parameter for the CPU module in HWCONFIG again. 16#620D The transmitted data length set in the UDP socket function is illegal. 1. Check the program and the related special data registers. 2. Set the Ethernet parameter for the CPU module in HWCONFIG again.

16#620E The data which is sent through the UDP socket exceeds the device range. 1. Check the program and the related special data registers. 2. Set the Ethernet parameter for the CPU module in HWCONFIG again. 16#620F The device which receives the data in the UDP socket function is illegal. 1. Check the program and the related special data registers. 2. Set the Ethernet parameter for the CPU module in HWCONFIG again. 16#6210 The received data length set in the UDP socket function is illegal. 1. Check the program and the related special data registers. 2. Set the Ethernet parameter for the CPU module in HWCONFIG again.

16#6211 The data which is received through the UDP socket exceeds the device range. 1. Check the program and the related special data registers. 2. Set the Ethernet parameter for the CPU module in HWCONFIG again. 16#6212 There is no response from the remote device after the timeout period. Make sure that the remote device is connected. 16#6213 The data received exceeds the limit. 1. Check the program and the related special data registers. 2. Set the Ethernet parameter for the CPU module in HWCONFIG again. 16#6214 The remote device refuses the connection. Make sure that the remote device operates normally. 16#6215 The socket is not opened.

Check whether operational sequence in the program is correct. 16#6217 The socket is opened. Check whether operational sequence in the program is correct. 16#6218 The data has been sent through the socket. Check whether operational sequence in the program is correct. 16#6219 The data has been received through the socket. Check whether operational sequence in the program is correct. 16#621A The socket is closed. Check whether operational sequence in the program is correct. 16#6303 The remote device in the Ether Link aborts the connection. 1. Check the connection and the status of the remote device. 2. Check whether the remote device supports the Ether Link.

16#6304 The connection in the Ether Link is busy. 1. Check whether the number of connections in the Ether Link exceeds the system load. 2. Retry the connection in the Ether Link later.