Mitsubishi — 9.2.3 Troubleshooting for AH05PM-5A/AH10PM-5A/AH15PM-5A

Chapter 9 Troubleshooting 9.2.3 Troubleshooting for AH05PM-5A/AH10PM-5A/AH15PM-5A The programs and the setting which are mentioned in the table below are edited in PMSoft version 2.02 or above. 9-31 Error Description Remedy code 16#A013 The moving average for channel 1 exceeds the range. Check the module parameter in HWCONFIG. The moving average for channel 1 should be within the range between 2 and 60. 16#A014 The comparison value for channel 1 exceeds the range. Check the module parameter in HWCONFIG. The comparison value for channel 1 should be within the range between -999999999 and 999999999. 16#A015 The limit value of the alarm output for channel 1 is incorrect.

Check the module parameter in HWCONFIG. The limit value of the alarm output for channel 1 should be within the range between -200000 and 200000. 16#A016 The interrupt number for channel 1 exceeds the range. Check the module parameter in HWCONFIG. The interrupt number for channel 1 should be within the range between 0 and 31. 16#A021 The linear accumulation in channel 2 exceeds the range. To clear the linear accumulation, users need to set bit 1 in CR56 to ON by means of FROM/TO. 16#A022 The prescale value for channel 2 exceeds the range. Check the module parameter in HWCONFIG. The prescale value for channel 2 should be within the range between 0 and 32767.

16#A023 The moving average for channel 2 exceeds the range. Check the module parameter in HWCONFIG. The moving average for channel 2 should be within the range between 2 and 60. 16#A024 The comparison value for channel 2 exceeds the range. Check the module parameter in HWCONFIG. The comparison value for channel 2 should be within the range between -999999999 and 999999999. 16#A025 The limit value of the alarm output for channel 2 is incorrect. Check the module parameter in HWCONFIG. The limit value of the alarm output for channel 2 should be within the range between -200000 and 200000. 16#A026 The interrupt number for channel 2 exceeds the range. Check the module parameter in HWCONFIG.

The interrupt number for channel 2 should be within the range between 0 and 31. 16#A031 The linear accumulation in channel 3 exceeds the range. To clear the linear accumulation, users need to set bit 1 in CR84 to ON by means of FROM/TO. 16#A032 The prescale value for channel 3 exceeds the range. Check the module parameter in HWCONFIG. The prescale value for channel 3 should be within the range between 0 and 32767. 16#A033 The moving average for channel 3 exceeds the range. Check the module parameter in HWCONFIG. The moving average for channel 3 should be within the range between 2 and 60. 16#A034 The comparison value for channel 3 exceeds the range. Check the module parameter in HWCONFIG.

The comparison value for channel 3 should be within the range between -999999999 and 999999999. 16#A035 The limit value of the alarm output for channel 3 is incorrect. Check the module parameter in HWCONFIG. The limit value of the alarm output for channel 3 should be within the range between -200000 and 200000. 16#A036 The interrupt number for channel 3 exceeds the range. Check the module parameter in HWCONFIG. The interrupt number for channel 3 should be within the range between 0 and 31. Error Description Remedy code