AH500 Module Manual Corresponding relation table for error slaves: 12-56 Item Content Description Treatment value error The low word of communicator error - Reserved - Configured slaves - The number of the slaves configured in the master. - Active slaves - The number of the slaves communicating with the master normally. - Error slaves 15…0 - When the master detects that the error on the slaves (of number 1~125) occurs such as offline, the corresponding bit becomes 1. (Here there are totally 128 (0~127) bits assigned. Since the node addresses of the slaves can not be 0, 126 and 127, the corresponding bit has no meaning.) Otherwise, it is 0.
For more details, see the following table on the error slaves. 1. Check if the PROFIBUS DP bus is connected correctly. 2. Check if either end of the network is added with the terminal resistor. Error slaves 31…16 …… Error slaves 127…112 Description Corresponding register Node address of corresponding slave device Error slaves 15…0 D7(bit15~bit0) 15~0 Error slaves 31…16 D8(bit15~bit0) 31~16 …… …… …… Error slaves 127…112 D14(bit15~bit0) 127~112