Kaiyi — 16.7.2 Error Codes and Trouble-shooting

AH500 Module Manual 16.7.2.2 I/O Module Error 16.7.2.3 Communication Error 16-28 Category Error code 7-segment display Explanation How to deal with 16#1003 - Modify the IP address when in RUN state. - Firmware error 16#1004 F7 Firmware update failure 1. Check if the two ends of the network are connected properly. 2. Perform the firmware update again. Category Error code 7-segment display Explanation How to deal with I/O module configuration error 16#2001 F9 Actually connected I/O module is different from that configured in the software. 1. Re-install I/O module 2. Repower ON 3. Re-download the configuration.

Backplane configuration error 16#2002 F8 Actually connected backplane is different from that configured in the software. 1. Re-install the backplane 2. Repower ON 3. Re-download the configuration. Extension backplane offline 16#2003 FA The connection between the main backplane and extension backplane are disconnected. 1. Check if the cable connection is normal. 2. Repower ON Category Error code 7-segment display Explanation How to deal with EtherNet/IP communication error 16#0106 - Ownership conflict 1. Check the scanner owner. 2. Modify the invalid scanner setup. 3. Change the connection into Multicast. EtherNet/IP communication error 16#0113 - Out of connections 1.

Check if the number of product connections exceeds the limit. 2. Reduce the number of product connections. 16#0100 - I/O connections duplicated 1. Check if I/O connections have been built in the system configuration. 2. Change the connection type into Listen Only. 16#0203 E3 I/O connection 1. Check if the network cable connection is normal.