AH500 Motion Control Module Manual 5-216 Input pin Name Function Data Setting value Time when a value is valid type AxesGroup Axes which execute interpolation WORD[6] [ , , , , , ] ______ 0: Not setting axes n: Adding the nth axis (n is in the range of 1 to 16.) (The first cell must be set.) The value of the AxesGroup input pin is valid when there is a transition in the Execute input pin’s signal from low to high. Position Target positions DWORD[6] [ , , , , , ] ______ K-2,147,483,648~ K2,147,483,647 The value of the Position input pin is valid when there is a transition in the Execute input pin’s signal from low to high.
Velocity Speed of interpolation DWORD K1~K2,147,483,647 The value of the Velocity input pin is valid when there is a transition in the Execute input pin’s signal from low to high. State of output pin Name Function Data type Time when there is Time when there is a transition in an output pin’s signal from high to low a transition in an output pin’s signal from low to high Done The execution of the function block is complete. BOOL There is a transition in the Done output pin’s signal from low to high when multiaxial absolute linear interpolation is complete.
There is a transition in the Done output pin’s signal from high to low when there is a transition in the Execute input pin’s signal from high to low. If the Execute input pin is set to False when motion is complete, the Done output pin will be set to False in the next cycle. Busy The motion control function block is being executed. BOOL There is a transition in the Busy output pin’s signal from low to high when there is a transition in the Execute input pin’s signal from low to high. There is a transition in the Busy output pin’s signal from high to low when there is a transition in the Error output pin’s signal from low to high.
There is a transition in the Busy output pin’s signal from high to low when there is a transition in the Done output pin’s signal from low to high.