Mitsubishi — 5.11.6 Multiaxial Relative Linear Interpolation

Chapter 5 Applied Instructions 3. Troubleshooting 4. Modules which are supported The motion control function block T_AbsMoveLinear supports AH05PM-5A, AH10PM-5A, AH15PM-5A, and AH20MC-5A. 5.11.6 Multiaxial Relative Linear Interpolation 1. Motion control function block The motion control function block T_RelMoveLinear is used to start multiaxial relative linear interpolation. Users can set the axes which execute interpolation by means of the AxesGroup input pin, set the distances for which the axes specified move by means of the Distance input pin, and set the speed of the axes specified by means of the Velocity input pin. 2.

Input pins/Output pins 5-217 State of output pin Name Function Data type Time when there is Time when there is a transition in an output pin’s signal from high to low a transition in an output pin’s signal from low to high Error An error occurs in the motion control function block. BOOL  Input values are incorrect.  There is a transition in the Error output pin’s signal from high to low when there is a transition in the Execute input pin’s signal from high to low. Aborted The execution of the motion control function block is interrupted by a command. BOOL  The execution of the motion control function block is interrupted by a command.

 There is a transition in the Aborted output pin’s signal from high to low when there is a transition in the Execute input pin’s signal from high to low. Error Troubleshooting The values of input pins in the motion control function block are incorrect. Check whether the values of the input pins are in the ranges allowed. Input pin Name Function Data Setting value Time when a value is valid type AxesGroup Axes which execute interpolation WORD[6] [ , , , , , ] ______ 0: Not setting axes n: Adding the nth axis (n is in the range of 1 to 16.) (The first cell must be set.) The value of the AxesGroup input pin is valid when there is a transition in the Execute input pin’s signal from low to high.