Mitsubishi — 5.13.8 Setting High-speed Capture

AH500 Motion Control Module Manual 3. Troubleshooting 4. Modules which are supported The motion control function block T_CmpOutRst supports AH05PM-5A, AH10PM-5A, AH15PM-5A, and AH20MC-5A. 5.13.8 Setting High-speed Capture 5-252 State of output pin Name Function Data type Time when there is Time when there is a transition in an output pin’s signal from high to low a transition in an output pin’s signal from low to high Busy The motion control function block is being executed. BOOL  There is a transition in the Busy output pin’s signal from low to high when there is a transition in the Enable input pin’s signal from low to high.

 There is a transition in the Busy output pin’s signal from high to low when there is a transition in the Error output pin’s signal from low to high.  There is a transition in the Busy output pin’s signal from high to low when there is a transition in the Enable input pin’s signal from high to low. Error An error occurs in the motion control function block. BOOL  Input values are incorrect.  The source specified has been occupied.  There is a transition in the Error output pin’s signal from high to low when there is a transition in the Enable input pin’s signal from high to low.

Value of output pin Name Function Data Output range Time when a value is valid type CMP Y08 _ States of the output devices Y0.8, Y0.9, Y0.10, Y0.11, C200, C204, C208, and C212 BOOL True/False When the Valid output pin is set to True, the values of these output pins are updated repeatedly. CMP Y09 _ CMP Y010 _ CMP Y011 _ CMP C200Rst _ CMP C204Rst _ CMP C208Rst _ CMP C212Rst _ Error Troubleshooting The values of input pins in the motion control function block are incorrect. Check whether the values of the input pins are in the ranges allowed.