AH500 Motion Control Module Manual 7-6 Motion SR number JOG motion Returning home Single-speed motion Inserting single-speed motion Two-speed motion Inserting two-speed motion Variable motion Manual pulse generator mode (1+N)th axis Function HW LW - SR1021+100*N Time (T ) it takes for DEC the axis specified to decelerate ◎ ◎ ◎ ◎ ◎ ◎ ◎ - SR1023+100*N SR1022+100*N Target position of the axis specified (P (I)) - - ◎ ◎ ◎ ◎ - ◎ SR1025+100*N SR1024+100*N Speed at which the axis specified rotates (V (I)) - - ◎ ◎ ◎ ◎ ◎ - SR1027+100*N SR1026+100*N Target position of the axis specified (P (II)) - - - - ◎ ◎ - ◎ SR1029+100*N SR1028+100*N Speed at which the axis specified rotates (V (II)) - - - - ◎ ◎ - - - SR1030+100*N Operation command ◎ ◎ ◎ ◎ ◎ ◎ ◎ ◎ - SR1031+100*N Mode of operation ◎ ◎ ◎ ◎ ◎ ◎ ◎ ◎ SR1033+100*N SR1032+100*N Present command position of the axis specified (Pulse) ◎ ◎ ◎ ◎ ◎ ◎ ◎ ◎ SR1035+100*N SR1034+100*N Present command speed of the axis specified (PPS) ◎ ◎ ◎ ◎ ◎ ◎ ◎ ◎ SR1037+100*N SR1036+100*N Present command position of the axis specified (Unit) ◎ ◎ ◎ ◎ ◎ ◎ ◎ ◎ SR1039+100*N SR1038+100*N Present command speed of the axis specified (Unit) ◎ ◎ ◎ ◎ ◎ ◎ ◎ ◎ - SR1042+100*N Electronic gear ratio of the axis specified (Numerator) - - - - - - - ◎ - SR1043+100*N Electronic gear ratio of the axis specified (Denominator) - - - - - - - ◎ SR1045+100*N SR1044+100*N Frequency of pulses generated by the manual pulse generator for the axis specified - - - - - - - ◎