Mitsubishi — 7.1 Functions of Uniaxial Motion

AH500 Motion Control Module Manual SR1020+100*N is greater than 32,767, it will be counted as 32,767.  If users want to have a complete S curve, the maximum speed which is set must be the same as the speed at which the axis specified operates. 7. Time (T DEC ) it takes for the axis specified to decelerate [Description]  Users can set the times it takes for the speed of the axis specified to decrease from its maximum speed to its start-up speed. The value in SR1021+100*N is in the range of 0 to 32,767. A millisecond is a unit.  If the value in SR1021+100*N is less than 10, it will be counted as 10. If the value in SR1021+100*N is greater than 32,767, it will be counted as 32,767.

 If users want to have a complete S curve, the maximum speed which is set must be the same as the speed at which the axis specified operates. 8. Present command position of the axis specified (Pulse) [Description]  The value in (SR1033+100*N, SR1032+100*N) is in the range of -2,147,483,648 to +2,147,483,647.  The present command position of the axis specified is indicated by the number of pulses. (The unit used is determined by bit 0 and bit 1 in SR1000+100*N.) After the axis specified returns home, the value in (SR1019+100*N, SR1018+100*N) will be written into (SR1033+100*N, SR1032+100*N). 9.

Present command speed of the axis specified (PPS) [Description]  The value in SR1035+100*N is in the range of 0 to 2,147,483,647. 10. Present command position of the axis specified (Unit) [Description]  The value in (SR1037+100*N, SR1036+100*N) is in the range of -2,147,483,648 to +2,147,483,647.  The unit used is determined by bit 0 and bit 1 in SR1000+100*N. After the axis specified returns home, the value in (SR1019+100*N, SR1018+100*N) will be written into (SR1037+100*N, SR1036+100*N). 7-12 (1+N)th axis HW LW - SR1021+100*N (1+N)th axis HW LW SR1033+100*N SR1032+100*N (1+N)th axis HW LW - SR1035+100*N (1+N)th axis HW LW SR1037+100*N SR1036+100*N