Mitsubishi — 7.3.1 Related Special Data Registers

Chapter 7 Uniaxial Motion 3. Uniaxial motion is controlled by SR1030+100*N. After the parameters related to motion are set, the motion can be started. [Description] 7.3 Introduction of JOG Motion 7.3.1 Related Special Data Registers 1. JOG speed (V JOG ) at which the axis specified rotates [Description]  Users can set the JOG speed (V JOG ) at which the axis specified rotates. The value in (SR1011+100*N, SR1010+100*N) is in the range of 0 to 2,147,483,647. (The unit used is determined by bit 0 and bit 1 in SR1000+100*N.)  The frequency of pulses generated by motion is in the range of 10 PPS to 1000K PPS.

If the value in (SR1009+100*N, SR1008+100*N) is greater than 1000K, the frequency of pulses generated will be 1000K PPS. If the value in (SR1009+100*N, SR1008+100*N) is less than 10, the frequency of pulses generated will be 10 PPS.  V MAX >V JOG >V BIAS If the V JOG set is greater than the V MAX set, the actual V JOG will be equal to the V MAX . If the V JOG set is less than the V BIAS set, an error will occur. When an axis operates, users can modify the JOG speed of the axis. If the value in (SR1011+100*N, SR1010+100*N) is 0, the JOG motion of the axis specified will be stopped, and will needs to be started again.

If JOG motion is started when the value in (SR1011+100*N, SR1010+100*N) is 0, an error will occur. 7-15 (1+N)th axis Operation command HW LW - SR1030+100*N Special data register SR1030+100*N b15 b14 b13 b12 b11 b10 b9 b8 b7 b6 b5 b4 b3 b2 b1 b0 - - - The execution of the Ox motion subroutine set starts. A mode of inserting two-speed motion is activated. A mode of two-speed motion is activated. A mode of inserting single-speed motion is activated. A mode of single-speed motion is activated. - A mode of triggering the return to home is activated. A manual pulse generator is operated. A mode of variable motion is activated. The axis specified operates in JOG- mode.

The axis specified operates in JOG+ mode. - The motion of the axis specified is stopped by software. (1+N)th axis HW LW SR1011+100*N SR1010+100*N